What are you going to learn?
Contents:
- Introduction to drawing.
- Basics drawing tools. Instruments for technical drawing and graphic design
- Drawing parallel lines, perpendicular lines and angles. With the use of set-squares and protractors
- Rough drafts, sketch and technical drawing
- Standardization: measurement
- Scales: enlargement and reduction scales
- Measurement in technical drawing. Dimensions and types of lines
- Dihedral projection (overhead or top view, front view and side view)
Activities to be included in the notebook:
- Activity 1 on page 53 (class)
- Activities 2 and 3 on page 54
- Scales (it´s not in the book) enlargement and reduction scales. Just two examples from the slides
- Activities 10 and 11 on page 57
- Activity 7 on page 55
- Activity 12 on page 60
- Act 14 on page 65
- Activities from the photocopies in Moodle. Views of the Objects
Reinforcement Activities:
- Unit summary on page 62
- Comprehension activities. 1, 2, 4, 7 page 64
- MOODLE TESTS: Drawing general test, Scales, Views and Vocabulary